Skip to content

Motor Vehicle Tire Safety Regulations

SOR/2013-198

In forceCurrent to September 30, 2026 HistoryRegistered on November 8, 2013Made under: Motor Vehicle Safety Act

Follow

Section 7

Marginal note:National Safety Mark

  •  (1) For the purposes of these Regulations, the symbol set out in Figure 1 of Schedule 1 is prescribed as the national safety mark.

  • Marginal note:Authorization by Minister

    (2) For the purposes of subsection 3(2) of the Act, on application by a company, the Minister may, in the form set out in Schedule 2, authorize the company to apply the national safety mark to a tire.

  • Marginal note:Application of the national safety mark

    (3) For the purposes of subsection 3(2) of the Act, when a company applies the national safety mark to a tire, the company must

    • (a) reproduce the symbol set out in Figure 1 of Schedule 1 with the minimum height specified in Figure 3 of that Schedule; and

    • (b) permanently mould the symbol into or onto one sidewall of the tire

      • (i) in one of the places shown in Figure 3 of Schedule 1, and

      • (ii) at a depth or height of not less than 0.5 mm and not more than 1 mm as measured from the immediate surrounding surface of the sidewall.

  • SOR/2020-22, s. 29
.

Version in force since February 4, 2020

Unofficial reproduction of the consolidated text published by the Department of Justice Canada, permitted by the Reproduction of Federal Law Order. Only the official text is authoritative.